Have you recently purchased a new D - Link router to your computer system to add? At that time, most families have more than one computer, many Wi-Fi to surf the Internet. The establishment of these devices is not too difficult a task, but sometimes you need to consider the company's broadband cable and use the specifications you might have. This is a brief introduction, which is the most common way is to configure a D -> Link Router.
Before you begin, make sure you have all the necessary supplies like cables, Power Supply and the installation instructions and the hard drive and an electrical outlet. Also make sure that the cable modem is not connected. Make sure your computer is turned off before installation (often newer routers can automatically configure the boot).
D Link
Please follow these steps for your D - Link router configuration:
Take the Ethernet cable from the modemThe computer and disconnect it from your computer. Plug into the router's WAN port. This is a new setup, and is not connected to a PC and go to the cable modem "ethernet port on the router's WAN port. If you want to connect to a PC, use another ethernet cable from the router and go D -. link port on your PC when you are all Wireless, no need to take this step.
Once the connection is via cable modem connected to the router, connect boththe router and the back of the modem and restart your computer. I hope you see the Lights flashing LED means that the router works and the d - Link router configuration is correct, because talking to each other.
After the computer again, you must configure the D - link router set all configurations. Open Internet Explorer or your favorite browser and type the IP address 192.168.0.1 generic. Consult the manual will beAccess to them first.
From here, you will create a user name and password, and make sure the firmware is updated. If it is Wireless, make sure your SSID and be sure to create a unique name for the router. Make sure you enable encryption, so that the people in your family can not use Wireless.
You might want to take other measures, if you do your d - link configuration of the router as parental control, firewall, and even ifonly one specific computer (with a MAC address) to access the network.
To configure a router D-Link
No comments:
Post a Comment